×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
16 Dec 2020
The Joomla and Kunena packages have been updated to the latest versions.
  • Page:
  • 1
  • 2

TOPIC:

inlet manifolds 10 years 4 months ago #3287

  • Kano Nordi
  • Kano Nordi's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1728
  • Thank you received: 22
I made 4 cast inlet manifolds with hose connectors to fit the carbs, anybody interested?
John

Re: inlet manifolds 10 years 4 months ago #3289

  • Joachim
  • Joachim's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1026
  • Thank you received: 42
like always,i am interested in anything ;)
Send pics ....
I think Luca is also working on that things.
At the german Forum there is a member which neeeds this part because her old one has some holes :(
So maybe we can give her a little help.

ciao Joachim

Re: inlet manifolds 10 years 4 months ago #3290

  • Kano Nordi
  • Kano Nordi's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1728
  • Thank you received: 22
Hi Joachim I tried to post a picture but it did not accept, so will mail it to you
Cheers
John

Re: inlet manifolds 10 years 4 months ago #3291

  • Joachim
  • Joachim's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1026
  • Thank you received: 42
Thanks for the pics.
I did not notice that they are for the CR carbs.
But looking at that.... would it be possibel to cut away all the old rubber from the original part and make connections with those kind of rubber hose?
Maybe i should have a look.

ciao Joachim

Re: inlet manifolds 10 years 4 months ago #3292

  • Kano Nordi
  • Kano Nordi's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1728
  • Thank you received: 22
Hi Joachim they will fit CR or TK carbs, the same diameter and spacing, if you cut away the rubber on the standard manifolds the aluminum casting is too short to fit the rubber hose, I pressed in steel inserts to extend the length then got casting made ;)

Re: inlet manifolds 10 years 4 months ago #3293

  • Joachim
  • Joachim's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1026
  • Thank you received: 42
Kano Nordi wrote:

if you cut away the rubber on the standard manifolds the aluminum casting is too short to fit the rubber hose,)


Uuups. So no chance for a 'russian' repair :unsure:

thanks and ciao Joachim
  • Page:
  • 1
  • 2
Time to create page: 0.217 seconds
Powered by Kunena Forum