GeN Banner

×

Notice

The forum is in read only mode.

Welcome, Guest

Nordwest & RC600

Cambelt change tool

×

Site and Forum Software Update

16 Dec 2020

The Joomla and Kunena packages have been updated to the latest versions.

Nordwest & RC600 Forum

Page:
1
2

TOPIC:

Cambelt change tool 7 years 10 months ago #5232

foz Topic Author Offline New Member Posts: 18 Thank you received: 0	Gents, does the club or any members have the cambelt change tool that i could borrow or hire, happy to cover postage costs etc. Regards foz

Re: Cambelt change tool 7 years 10 months ago #5233

Kano Nordi Offline Platinum Member Posts: 1728 Thank you received: 22	Hi Foz, Bob Wright normally has them in stock, or if you are handy with a lathe not hard to make?? if you were local I could lend you mine John

Re: Cambelt change tool 7 years 10 months ago #5234

overbomber Offline Platinum Member Posts: 847 Thank you received: 2	The original GeN had a tool service for its members but alas those days are gone. About £28 from Bob, or make one as John suggests. It's worth having one that's for sure.

Re: Cambelt change tool 7 years 10 months ago #5235

Joachim Offline Platinum Member Posts: 1026 Thank you received: 42	if you can get it made for free... i can send a little sketch ciao Joachim

Re: Cambelt change tool 7 years 9 months ago #5236

foz Topic Author Offline New Member Posts: 18 Thank you received: 0	A sketch would be good, I can get most bits made up. foz

Re: Cambelt change tool 7 years 9 months ago #5237

Joachim Offline Platinum Member Posts: 1026 Thank you received: 42	could you please send me a PM with an e-mail adress to send the sketch ciao Joachim

Page:
1
2

Nordwest & RC600

Cambelt change tool

Time to create page: 0.025 seconds

Powered by Kunena Forum