×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
Forum
Machines
Nordwest & RC600
Water pump Seals
×

Site and Forum Software Update

16 Dec 2020
The Joomla and Kunena packages have been updated to the latest versions.
Nordwest & RC600 Forum

TOPIC:

Re: Water pump Seals 7 years 11 months ago #5145

  • Joachim
  • Joachim's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1026
  • Thank you received: 42
hookooekoo wrote:

...thro i had to take a bit of thickness of the impellor as new seals are a bit thicker


That's what the Burgmann engineers also told me whne i bought the seals many years ago.
How much did you take away?
1mm?
If i remeber right that's what they suggested. Otherwise the preload on the seals would make troubble.

ciao Joachim

Re: Water pump Seals 7 years 11 months ago #5146

  • hookooekoo
  • hookooekoo's Avatar
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 24
  • Thank you received: 0
To be honest i just used a twisting motion holding the 'thin end' of the impellor flat against some wet/dry paper on a flat surface, it was very easy to remove about 1mm which i think is correct, anyway its fitted and working!!

Re: Water pump Seals 7 years 11 months ago #5147

  • Joachim
  • Joachim's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1026
  • Thank you received: 42
no matter how you did it, you just did it ;)
I am thinking about to do it sometimes... since years ;)

ciao Joachim

Re: Water pump Seals 7 years 11 months ago #5148

  • Kano Nordi
  • Kano Nordi's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1728
  • Thank you received: 22
Joachim,
Time to get up and go for it, after all it was you who put me onto Burgmann, how long ago ;)
John
Forum
Machines
Nordwest & RC600
Water pump Seals
Time to create page: 0.026 seconds
Powered by Kunena Forum